ST 公司的STA339BW是 2.1通路數字音頻系統方案,集成了數字音頻處理,數字放大器控制和FFX功率輸出級.STA339BW是基于ST所有權的完全靈活放大(FFX）處理器,它可配置成工作在三重模式,二元模式,差分二元和相移PWM調制模式. STA339BWS功率部分四個相互獨立的半橋,能配置成不同的模式,提供高達2 x 9 W + 1 x 20 W的功率輸出.工作電壓從5 V 到26 V.內部取樣速率96kHz,可達到28位的精度.本文介紹了STA339BW的主要特性,方框圖以及多種應用電路,包括電源,PLL應用,以及立體聲BTL模式輸出配置電路圖.
STA339BW 2.1-channel high-efficiency digital audio system
The STA339BW is an integrated solution of digital audio processing, digital amplifier control, and FFX-power output stage, thereby creating a high-power single-chip FFX® solution comprising high-quality, high-efficiency, all digital amplification.
STA339BW is based on FFX (fully flexible amplification) processor, a STMicroelectronics
proprietary technology. FFX is the evolution and the enlargement of the ST ternary
technology: the new processor can be configured to work in ternary, binary, binary
differential and phase shift PWM modulation schemes.
STA339BW contains the ternary, binary and binary differential implementations, a subset of the full capability of the FFX processor.
The STA339BW is part of the Sound TerminalTM family that provides full digital audio
streaming to the speaker, offering cost effectiveness, low power dissipation and sound
enrichment.
The STA339BW power section consists of four independent half-bridges. These can be
configured via digital control to operate in different modes. 2.1 channels can be provided by two half-bridges and a single full-bridge, providing up to 2 x 9 W + 1 x 20 W of power output.
Two channels can be provided by two full-bridges, providing up to 2 x 20 W of power. The IC can also be configured as 2.1 channels with 2 x 20 W provided by the device and external power for FFX power drive.
Also provided in the STA339BW are a full assortment of digital processing features. This
includes up to 7 programmable 28-bit biquads (EQ) per channel and bass/treble tone
control. Available presets enable a time-to-market advantage by substantially reducing the amount of software development needed for certain functions. This includes audio preset volume loudness, preset volume curves and preset EQ settings. There are also new advanced AM radio interference reduction modes. Dual band DRC dynamically equalizes the system to provide speaker linear frequency response regardless output power level.
This feature independently processes the two bands, controlling, dynamically, the output
power level in each band and so providing a better sound quality.
The serial audio data input interface accepts all possible formats, including the popular I2S format. Three channels of FFX processing are provided. This high-quality conversion from PCM audio to FFX PWM switching waveform provides over 100 dB SNR and dynamic range.
STA339BW主要特性:
Wide voltage supply range
5 V to 26 V (operating range)
30 V (absolute maximum rating)
3 power output configurations
2 channels of ternary PWM (stereo mode) (2 x 20 W into 8 at 18 V)
3 channels - left, right using binary and LFE using ternary PWM (2.1 mode) (2 x 9 W +
1 x 20W into 2 x 4 , 1 x 8 at 18 V)
2 channels of ternary PWM (2 x 20 W) + stereo lineout ternary
2.1 channels of 24-bit FFX®100 dB SNR and dynamic range
Selectable 32 to 192 kHz input sample rates
I2C control with selectable device address
Digital gain/attenuation +48 dB to -80 dB with
0.5 dB/step resolution
Soft volume update with programmable ratio Individual channel and master gain/attenuation
Two independent DRC configurable as a dualband anti-clipper (B2DRC) or independent
limiters/compressors
EQ-DRC for DRC based on filtered signals
Dedicated LFE processing for bass boosting with 0.5 dB/step resolution
Audio presets:
15 preset crossover filters
5 preset anti-clipping modes
Preset night-time listening mode
Individual channel and master soft/hard mute
Independent channel volume and DSP bypass
Automatic zero-detect mute
Automatic invalid input-detect mute
2-channel I2S input data interface
Input and output channel mapping
Up to 8 user-programmable biquads per channel with 28-bit resolution
3 coefficients banks for EQ presets storing with fast recall via I2C interface
Bass/treble tones and de-emphasis control
Selectable high-pass filter for DC blocking
Advanced AM interference frequency switching and noise suppression modes
Selectable high- or low-bandwidth noise-shaping topologies
Variable max power correction for lower full-power THD
Selectable clock input ratio
96 kHz internal processing sample rate, 24 to 28-bit precision
Thermal overload and short-circuit protection embedded
Video apps: 576 x Fs input mode supported
Fully compatible with STA339BWS.
圖1.STA339BW方框圖
圖2.STA339BW應用電路圖(電源)
圖2.PLL濾波器電路圖
圖3.STA339BW立體聲BTL模式輸出配置圖
|
